As for tools, everything necessary and more is included, and Flsun is also generous with other spare parts. The printer handled the intricate FLSUN indents perfectly, as well as the elephant’s eye, and without any stringing. The Voltcraft SL-10 sound level meter still shows a maximum volume of around 60 dBA even at a distance of one meter (~3.

As soon as the distance from nozzle to print bed is correct, there are hardly any problems with PLA adhesion. Workhorse: no print failed, and any messier prints were because we should have better optimized the support settings. The rods are straight, the illusion of a bend in the photo is only created by the wide-angle lens of my camera.I have found this from the flsun qqs facebook group that someone made, uploaded it to the SD, started duetwifi 192. No BL Touch on this Delta, it is indeed a specific sensor that you have to remove once the plate adjustment is done, it is not necessary to put the sensor back at each print, for my different print tests, I didn’t need to do it again, and I was able to make about 10 prints without any problem. In principle, both operating concepts are appealing, even if some functions are somewhat hidden in Marlin, since it is not always clear whether a screen element is also an operating element.

The QQ can run at speeds of up to 300mm/second and has been voted as the fastest 3d printer available in 2021, for under 500 USD. Then I move the printer to start position and use the status page babystep to fine adjust with a paper before print. PrinterMods is a proud cog in that machine - supplying the maker community with what they need to grow and thrive. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.If you are looking for a fast 3D printer, you need a Delta 3D printer, if you are looking for a fast and cheap 3D printer, you need a QQ-s Pro! I didn’t encounter any problems during these prints, and I also had a very good grip, this self-levelling sensor is very efficient, even when printing on the whole surface of the board. Due to their length, the cables could get in the way of the axle slides and be damaged by friction or pinching. Behind this is relatively simple mathematics based on the Pythagorean theorem (a²+b²=c²), which is translated into fast and interesting to observe movements. The easiest solution for us here is to fall back on the 3D printing community and install an alternative firmware on the device.

Hi all, I am new to this, I have bought a Duet 2 Wifi for my FLSUN-QQ-S-Pro and I have no idea how to configure the reprap firmware for it for my printer profile. It has a flexible three-axis linkage system, a powerful 32-bit motherboard, a 24V power supply, a lattice hot bed, and an all-metal side shell to ensure better printing quality and a more stable structure. Once assembled the machine seems quite stable, and the components of good quality, the belt tensioning system (the little knobs on top of the machine) are quite practical.

However, the WLAN connection was partly difficult in the test, since the small ESP8266 is well shielded by the metal casing.

By accepting all cookies, you agree to our use of cookies to deliver and maintain our services and site, improve the quality of Reddit, personalize Reddit content and advertising, and measure the effectiveness of advertising. Widely used in toy, architecture, furniture, education, medical, daily necessities and other fields.In an emergency, the corresponding heating elements are on full power until they burst into flames or melt the surrounding plastic. You do have to master a few English words here, but once again the video instructions explain how to operate the printer. This is a mechanical switch, which must be attached to the print head via a magnet before starting the procedure. The extrusion quantities in the extrusion test are not necessarily stable, but our measurements here can also only reflect the real behavior of the extruder to a limited extent.