Remove all of the dirt and grime with your grip gum or rubber. Skateboard grip gum is a high-quality product that cleans your board well. Rub the grip tape like you would a pencil eraser, then brush away the residue. Thoroughly clean your board with grip gum once in a while to keep it looking new. Method 2. Cleaning Grip On A Longboard Remove leftover grime with grip gum. Most skate shops sell grip gum meant specifically for skateboards, and they’re great products for cleaning. Rub at the grip tape like you would with a pencil eraser, then brush away the residue. Doing a thorough pass with grip gum will leave your board looking brand new. Immediately wipe the dirty water from the grip tape using a towel or Paper Towel and do not let the water soak into the grip tape

I wanted to make the ultimate grip to go on all my bikes: AM to DH. I combined the following features and the DeathGrip is what we ended up with!’ The Secure denture adhesive is primarily designed for problematic lower dentures, though it’s also good for uppers. It provides a long-lasting, strong, and secure bond between dentures and gum, being effective even in cases of very narrow and flat lower ridges. Point the hot airflow directly at the wax on your grip tape. Be careful not to overheat the grip tape or hold the hairdryer too close to avoid any damage. Additionally, if you are in Portland, Eugene, or Bend, feel free to visit one of our local shops and speak to one of our friendly and helpful retail employees. They'll be more than happy to assist you and provide any information or guidance you need. Don't hesitate to reach out to us - we're here to help!Following are the some of the effective ways that I use to clean my transparent or coloured grip tape and so far it has given me effective results. Proper cold is, believe or not, another issue for sole makers. For perspective, winter spec car tyres are designed to works at temperatures of 7˚C and below, retaining their softness thanks to a careful mix of natural and synthetic rubbers, while ‘normal’ summer rubber compounds become rigid and far less grippy. The same basically happens with footwear, but there are special compounds available which are designed to work at lower temperatures. Swedish cold condition specialist Icebug, for example, uses a winter-specific sole unit produced by Michelin.

Not only could you injure yourself by slipping off when riding, but you could also hurt someone else when they step on your board. Also, the dirt and grime build-up causes your grip tape to lose traction. Even though this is a safety issue, it’s probably the least serious problem you’ll have if you neglect cleaning your grip tape. As mentioned earlier, cleaning the grip tape of any board is similar. However, longboard Grip tapes are really coarse, and using the wire brush or rubber piece alone may not get the job done. Since longboard grip tapes are very coarse and these are not perforated, it is OK to use water if needed. If your grip tape is covered in stubborn crusty mud, our next method of cleaning it isthe brush method. This is a great option that just requires a bit more effort. Here's what you'll need: In other words, it’s not just intuition or guesswork, there’s proper lab testing before lab life-type testing and finally outdoor field testing. Phew… If the grip is soiled to the point that it cannot be cleaned, you may need to replace it entirely. Step 2. Use Rubber to Remove Surface CrudAgain, you will need a soft wire brush. You will also need soft rubber, a microfiber cloth, and some soapy water. Step 1. Fill A Bowl With Soap & Water By laying your board upside down, you ensure the water moves away from the adhesive instead of sinking into it more. 9 – Be content.